1-9-1 E8E6DFW
FIRMWARE RENEWAL MODE
1. Turn the power on and remove the disc on the tray.
2. To put the DVD player into version up mode, press
[DVD], [9], [8], [7], [6], and [SEARCH] buttons on
the remote control unit in that order. The tray will
open automatically.
Fig. a appears on the screen.
The DVD player can also enter the version up
mode with the tray open. In this case, Fig. a will be
shown on the screen while the tray is open.
3. Load the disc for version up.
4. The DVD player enters the F/W version up mode
automatically. Fig. b appears on the screen. Make
sure to insert the proper F/W for the state of this
model.
The appearance shown in (*1) of Fig. b is
described as follows:
5. After programming is finished, the tray opens
automatically. Fig. c appears on the screen and
the checksum will be shown in (*2) of Fig. c.
At this time, no button is available.
6. Remove the disc on the tray.
7. Unplug the AC cord from the AC outlet. Then plug
it again.
8. Turn the power on by pressing the [ ] button and
the tray will close.
9. Press [1], [2], [3], [4], and [DISPLAY] buttons on
the remote control unit in that order.
Fig. d appears on the screen.
10. Press [CLEAR] button on the remote control unit.
Fig. e appears on the screen.
When “OK” appears on the screen, the factory
default will be set. Then the firmware renewal
mode is complete.
11. To exit this mode, press [ ] button.
No. Appearance State
1 Reading... Sending files into the memory
2 Erasing... Erasing previous version data
3 Programming... Writing new version data
F/W Version Up Mode Model No : *******
VERSION : *.**
Please insert a DISC
for F/W Version Up.
EXIT: POWER
"
*******
" differs depending on the models.
Fig. a Version Up Mode Screen
VERSION : ************.***
Reading...
F/W Version Up Mode Model No : *******
VERSION : *.**
Fig. b Programming Mode Screen
"
*******
" differs depending on the models.
(*1)
VERSION :
Completed
SUM : 7ABC
F/W Version Up Mode
Model No : *******
VERSION : *.**
************.***
"
*******
" differs depending on the models.
Fig. c Completed Program Mode Screen
MODEL : *******
Version
: *.**
Region
: *
EXIT: POWEREEPROM CLEAR : CLEAR
Fig. d
"
*******
" differs depending on the models.
MODEL : *******
Version
: *.**
Region
: *
EEPROM CLEAR : OK
EXIT: POWEREEPROM CLEAR : CLEAR
"
*******
" differs depending on the models.
Fig. e
To Next Page
Loading...
