Philips DVT6000 - Switching Silent Recording On and Off; Enabling;Disabling the Pre-Recording Function

42
Settings
Table of contents
9.1.8 Switching silent recording on and o
Use this function to turn o display indication, LED status, and the
signal tones during a recording. This allows you to record while there
is no visible indication on the display that a recording is being made.
1
In stop mode (start-up screen), press MENU.
2
Press the h / b key to select the record settings menu Ó.
3
Press + / – to select the Silent recording function.
4
Press the record key, g, to confirm.
5
Press + / – to enable/disable the function.
6
Press the record key, g, to confirm.
7
Press the j key to exit the menu.
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.
9.1.9 Enabling/disabling the pre-recording function
The pre-recording function allows to record the last five seconds
before you press the record key. The device switches into a standby
mode and records a five-second loop without saving it. Press the
record key to save the five-second loop.
1
In stop mode (start-up screen), press MENU.
2
Press the h / b key to select the record settings menu Ó.
3
Press + / – to select the Pre-recording function.
4
Press the record key, g, to confirm.
5
Press + / – to enable/disable the function.
6
Press the record key, g, to confirm.
7
Press the j key to exit the menu.
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.