8
2. Setting up the monitor
Note
• MPRT: To reduce motion blur, LED
backlight will strobe synchronously
with screen refresh, which may
cause noticeable brightness change.
• 75Hz refresh rate or higher is re-
quired for MPRT.
• AdaptiveSync and MPRT cannot be
enabled simultaneously.
• MPRT is to adjust brightness for blur
reduction, so cannot adjust bright-
ness while MPRT is turned on.
• MPRT is gaming-optimized mode.
Turn on MPRT may cause noticeable
screen ickering. It is recommended
to turn o when you are not using
the gaming function.
Resolution notification
This monitor is designed for optimal
performance at its native resolution,
1920x1080. When the monitor is
powered on at a different resolution, an
alert is displayed on screen: Use
1920x1080 for best results.
Display of the native resolution alert can
be switched off from Setup in the OSD
(On Screen Display) menu.
Physical Function
Tilt
20°
-5°
Warning
• To avoid potential screen damage,
such as panel peeling, ensure that
the monitor does not tilt downward
by more than -5 degrees.
• Do not press the screen while
adjusting the angle of the monitor.
Grasp only the bezel.
2.3 Remove the Base Assembly
for VESA Mounting
Before you start disassembling the
monitor base, please follow the
instructions below to avoid any possible
damage or injury.
1. Place the display face down on a
smooth surface. Pay attention not to
scratch or damage the screen.
2. (1) Use screwdriver to loosen the
screw located at the bottom of
the base.
(2) Use your fingers to loosen the
screw located at the bottom of
the base,and remove the base
from the stand.
2
3
1
To Next Page
Loading...
Need help?
General