Manually Starting an NBP Measurement
6-10 EarlyVue VS30 Instructions for Use
During a QuickNBP measurement:
• The phrase QuickNBP appears in the lower right of the NBP numeric pane
• If NBP is set as the source for pulse rate, a question mark (-?-) appears in the Pulse
numeric pane after the QuickNBP is complete. An actual pulse rate value does not
appear until the next time a standard NBP is taken.
To manually start a QuickNBP, see “To manually start an NBP measurement” on
page 6-12.
If your system administrator has enabled the QuickNBP setting, the Start NBP button in
the NBP numeric pane appears as a Start QuickNBP button to indicate that starting the
measurement from the numeric pane always starts a QuickNBP measurement. You can
start a standard NBP measurement by opening the NBP menu and touching the Start/
Stop NBP button.
If your system administrator has not enabled the QuickNBP setting, you can start a
QuickNBP only from the NBP menu.
Manually Starting an NBP Measurement
You can start a manual NBP measurement at any time in any of the monitoring modes
(Spot Check, Interval, Continuous, or Alarms Off mode). Depending on the monitoring
mode, you can start manual measurements from the main screen, the NBP menu, or the
Interval Settings or Continuous Settings menu. The following table describes the
buttons for manually starting and stopping NBP measurements.
Location Button Notes
All Monitoring Modes
Main screen Standard Start and Stop buttons.
If your system administrator has enabled
QuickNBP, the buttons on the main
screen default to QuickNBP buttons.
When you start a QuickNBP from the
NBP menu, the Stop button on the main
screen changes to Stop QuickNBP.
When you start a STAT NBP from the
NBP menu, the Stop button on the main
screen changes to Stop STAT.
Start NBP
Stop NBP
Start QuickNBP
Stop QuickNBP
Stop STAT
To Next Page
Loading...