The Temp Numeric Pane
7-2 EarlyVue VS30 Instructions for Use
Reposition the monitor so you can access the probe cable port on the bottom of the
monitor (under the temperature module). Insert the probe cable connector into the port,
making sure that it clicks into place.
If you need to disconnect the probe cable, squeeze the connector to keep the locking
flange pressed against connector body while extracting the connector from the port.
The Temp Numeric Pane
The following illustration shows the components of the Temp numeric pane.
Probe cable port on
bottom of monitor
Probe cable
connector ready to
plug in
Probe cable connected
Locking flange on connector
37.1
o
C
Unit of measure
Probe site
Temperature measurement
(Oral)
39.0
36.0
High and low alarm
limits
Temp
To Next Page
Loading...