The EarlyVue VS30 Monitor
2-4 EarlyVue VS30 Instructions for Use
Left Side
The left side of the monitor provides ports for most measurement connectors. For CO2
input, you must slide the panel down to expose the connector.
Note
The port for the temporal temperature probe is on the left side of the monitor, as shown
in the following illustration. The port for the predictive temperature probe is located on
the bottom of the monitor. See “Bottom,” below.
Bottom
The port for the predictive temperature connector is located on the bottom (underside) of
the monitor (under the temperature probe module).
The task lamp is also located on the underside of the monitor, and can be used to
illuminate the work surface below the monitor. To turn on the task lamp, you touch the
task lamp icon on the main screen. See “Toolbar” on page 2-21.
CO
2
Input
(slide connector
cover down)
SpO
2
NBP
CO
2
Output
Temporal
temperature
Predictive temperature port (with
cable connected)
Task lamp
To Next Page
Loading...