Philips EasyAir SNS210 MC - Recommendations to design-in around EasyAir SNS210 MC with good RF signal

11 Design-in Guide - EasyAir SNS210 March 2020
Wire distance for remote mounting
It is recommended to keep the wire distance from sensor
to Xitanium SR LED driver less than 15 m and meet the wire
gauge requirement to guarantee the performance.
Luminaire-to-luminaire distance
If multiple luminaires with EasyAir SNS210 MC are used in
the same area, the distance between the different sensors
should be kept at least 1.5 m. This distance will minimize a
sensor from “seeing” the light variation of neighbouring
luminaires and reacting.
Recommendations to design-in around EasyAir
SNS210 MC with good RF signal
It is recommended to have one side metal wall distance
from EasyAir SNS210 MC antenna side wall greater than
100mm (assuming other metal walls are further away, see
figure 6 below).
0
0
1
2
3
4
5
6
20 40
signal loss [dB] vs
60 80 100 120
Distance (mm)
Signal loss [dB]
Figure 6. Transmission signal loss [dB] with distance to metal wall [mm].
Closer the metal wall, higher the signal loss.
Figure 5. Distance between sensors should be at least 1.5m apart.
≥ 1.5 m ≥ 1.5 m