1 When the carafe cleaning icon appears on the display, press the OK button if you want to
perform a cleaning cycle. You have 10 seconds to activate the quick clean procedure. Press
the escape button if you do not want to perform the quick clean procedure.
2 Remove the cup with the drink and place an empty cup under the milk dispensing spout
(Fig. 29).
Note: Make sure the milk dispensing spout is pulled out.
3 Press the OK button to start dispensing hot water.
Thorough cleaning of the milk carafe
To clean the milk carafe thoroughly, you have to do the following regularly:
1 Remove the lid of the milk dispensing unit.
2 Lift the milk dispensing spout out of the milk dispensing unit and remove the milk tube
from the milk dispensing spout (Fig. 30).
3 Remove the milk tube from the milk dispensing spout.
4 Rinse the milk tube and milk dispensing spout with lukewarm water thoroughly.
Weekly cleaning of the milk carafe
The milk dispensing spout consists of 5 components. Disassemble all components once a
week and clean them under the tap. You can also clean all components, except for the milk
container, in the dishwasher.
1 Milk tube
2 Rubber support
3 Milk frother
4 Milk frother connector
5 Housing of milk dispensing spout
Disassembling the milk dispensing spout
1 Press the release buttons on both sides of the top of the milk dispensing unit (1) and lift the
top off the milk container (2) (Fig. 31).
2 Turn the milk dispensing unit upside down and hold it firmly in your hand. Pull the milk
tube off the support (Fig. 32).
3 Press the release buttons on the milk frother and remove the milk frother from the the
rubber support (Fig. 33).
4 Pull the milk frother connector out of the milk frother (Fig. 34).
5 Rinse all components under a lukewarm tap.
Reassembling the milk carafe
1 To reassemble the milk dispensing spout, follow steps 2 to 4 of 'Disassembling the milk
dispensing spout' in reverse order.
22
English
To Next Page
Loading...
