Philips epiq 5 - Page 47

EPIQ 5 & 7 Training Manual
© 2016 Conquest Imaging
39
 Select a Supported Printer Medium.
 To perform DICOM verification now, click Automatically Perform
DICOM Verification After Saving?
 Click OK and Save.
 If you did not click: Automatically Perform DICOM Verification
After Saving? click Verify.
Edit Settings for a Configured Printer
To edit the settings for a printer that is already configured:
 Press Support.
 Click the Network/DICOM tab.
 Click Printers and select the desired printer name.
 If you want to change the number of copies, film display format,
or film orientation, click Edit, and enter the new settings.
 If available, click Advanced and, if necessary, edit those settings.
 Click OK.
Assign the Acquire 1 and Acquire 2 Controls to a Printer
To set the printer to be used for either Aquire1 or Aquire2:
 Touch Utilities.
 On the System tab, touch Setups.
 Click Setup Wizard  Basic Settings.
 Under Your Control Panel, click Edit.
 Select the Acquisition Type for Acquire 1 and Acquire 2.
DICOM Server Configuration
The DICOM standard supports several types of servers.
Note: The printer must be
verified before it can be
used.