EPIQ 5 & 7 Training Manual
© 2016 Conquest Imaging
Select your default server from the Devices menu.
Select the storage server for association with Acquire 1 and
Acquire 2. You can send to either a primary or a backup server.
Touch Utilities.
On the System tab, touch Setups.
Select Acquisition/Capture and Archive/Print.
Assign the desired server to each aquire control.
Use the Setup Wizard to Set up the System for Use with a
Server
Using the wizard guides you through all the needed steps to make
this task easy.
To open the wizard touch Utilities.
On the System tab, touch Setups and click on Setup Wizard.
Click Getting Started and click Next three times.
In Export and Storing Data, click Store to PACS (DICOM Data,
Image/CineLoops).
Then click Yes, I want to setup network connectivity and click
Network Connectivity.
For Add Your DICOM Devices, click Edit.
Change the settings as needed. Options?
Manually Set up the System for Use with a Server
Using the wizard is the easiest way to set up the system but if the
system is already set up and you only need to change some
parameter such as IP address using the manual setup is more
convienent.
Press Support and click Network/DICOM DICOM Selection.
Under DICOM Services Configuration, select the server that you
want to use and click Edit.
To Next Page
Loading...