Philips epiq 5 - Page 50

EPIQ 5 & 7 Training Manual
© 2016 Conquest Imaging
42
 Under Edit DICOM Device you can enter changes to the
 Device Type
 Device Name
 AE Title
 Port No.
 IP Address
 Click Advanced Settings and if necessary, select or change the
required settings.
 Confirm the settings and click Save.
 If you want to perform DICOM verification now, click
Automatically Perform DICOM Verification After Saving? And
click Save again.
 If you did not verify the server in the previous step, click Verify.
To Configure DICOM Parameters
For systems that are busy, slow, or for older networks setting these
DICOM parameters can help the performance until the network is
updated. In general, only someone who is well versed in DICOM
parameters would alter these. To access these settings:
 Press Support and Click the Network/DICOM  DICOM Settings.
 Select a DICOM server, and then click Edit.
 Under Edit DICOM Device complete any of the following fields:
 Max PDU Size specifies the maximum PDU (protocol data unit)
size.
 ARTIM Timeout specifies the Association
Request/Reject/Release Timer (ARTIM) time-out value.
 Network Reply Timeout specifies the amount of time that the
system will wait for a reply from the server.
 Idle Association Timeout specifies the amount of time
allowed for the system to maintain an idle association with
the server.