EPIQ 5 & 7 Training Manual
© 2016 Conquest Imaging
Click Save, and then click Save again.
DICOM Storage Commit
The DICOM Storage Commit (SC) feature allows users to archive
images to a network server and to receive a response from the SC
server that indicates that the server has received the storage request
and successfully stored the images.
The system sends storage commit requests to the SC server when all
images from an exam have been sent to the target archive device and
either a new exam has begun or the exam is paused.
However, if the system is configured to connect to an SC server and
sends images and clips immediately after acquistion, the system
requests storage commitment for each image or clip as it is acquired.
You can also configure the parameters under which the system
automatically resends exam content and storage commit requests.
Setting Auto-Retry for DICOM Storage Commit
The auto-retry is set with factory default options. You can change
these if needed.
To change auto-retry options:
Press Support.
Click the Network/DICOM DICOM Settings.
Select the desired DICOM storage commitment server and then
click Edit Auto-Retry Settings.
Select Automatically Retry Storage Commit and complete the
following:
Number of Retry Events Before Abandoning Storage
Commitment: You can specify the number of times the system
attempts to resend exam content and commitment requests
to the SC server before canceling the storage commit.
Retry Delay After No Response from Storage Commit Server:
You can specify the amount of time in hours the system waits
before resending a commitment request to the SC server
To Next Page
Loading...