Philips EverFlo Q - User Manual

!
Everflo Q
Operating instructions
Warning: Do not use extension cords or electrical adapters.
1. Select a location that allows the machine to draw in room air
without being restricted. Make sure the device is at least 15 to
30cm away from walls, furniture, and especially curtains that could
impede adequate airflow to the device. Keep away from heat.
2. Plug the power cord into an electrical outlet.
3. Do either Step a or Step b below
a. If you are not using a humidifier, connect your nasal cannula to
the Oxygen Outlet Port.
b. If you are using a humidifier, follow the steps below:
i. Open the filter door on the back of the device.
ii. Remove the humidifier connector tube from the back of
the door and replace the filter door.
iii.Fill your humidifier bottle according to the manufacturer's
instructions.
iv. Mount the filled humidifier on the top of the EverFlo
device inside the velcro strap, as shown in the illustration
on the right.
v. Tighten the velcro strap around the bottle and secure it so
it is held firmly in place.
vi. Connect the humidifier connector tube (that you retrieved
from the filter door) to the Oxygen Outlet Port.
vii.Connect the other end of the humidifier connector tube to
the top of the humidifier with the elbow in the tubing
facing the front.

Philips EverFlo Q Specifications

General

Brand	Philips
Model	EverFlo Q
Category	Oxygen Equipment
Language	English

Summary

Everflo Q Operating Instructions

General Safety Warning

Warning against using extension cords or electrical adapters with the device.

Location and Airflow Requirements

Ensure adequate airflow by placing the device 15-30cm from walls, furniture, and curtains. Keep away from heat.

Power Connection

Plug the power cord directly into an electrical outlet.

Cannula Connection Options

Connect nasal cannula directly or via humidifier following specific instructions.

Humidifier Setup and Connection

Mount humidifier, connect tubing to device and bottle, then connect cannula to humidifier.

Device Power On and Initialization

Press power switch to On; LEDs and audible alert will activate briefly; green LED should remain lit.

Flow Rate Adjustment

Adjust flow meter knob until the ball is centered on the line marking the specific flow rate.

Cannula Usage and Verification

Put on cannula as directed, ensure oxygen is flowing, and refer to manual if not.

Device Power Off

Press the power switch to the Off position when the oxygen concentrator is not in use.