10: Equipment Supplied: [at no cost to members]
• Philips FM92E band transceiver
• Remote Control Head or Speaker [for local control head].
• 2764 EPROM [already programmed for 6 meters – 77 FM channels].
• VHF Signal Generator
• RF Power Meter
• De-Soldering station
• Soldering Iron *
• 12 volt meter.
• Tuning stick.
• Grid Dip Oscillator.
• 50ohm RF cables.
• This document plus frequency v channel page.
• 50 watt plus soldering iron with big flat tip.
• Large File [rasp] *
• Methylated Spirits
• Tin Snips *
• Philips Screwdriver *
Note: * = Bring your own if you have one.
11: Equipment Required: [to be supplied by each member]
• Soldering Iron [if needed]
• Solder wick [if needed]
• Stanley Knife or Scapple or Box Cutter
• Tin snips [if needed]
• Pair of small tweezers
• Engraver with grinder [if needed]
• Hot glue gun [if needed]
• 12 volt meter [if needed]
• Small plastic GLAD bag for holding screws.
• A4 plastic GLAD bag for holding covers.
• Can of WD40.
• Mr Sheen, Armour-all or similar.
• 1cm or 2cm paint brush for cleaning.
• Sponge or cloth for cleaning.
• Masking Tape for cleaning.
• Tooth brush for cleaning.
• Can of black paint [if needed].
• In-Line Fuse holder & 8 or 10 amp fuse.
• 5 pin DIN plug [for speaker] or 3.5mm plug.
• 0.80mm [B&S 20] Enamelled Copper Winding Wire. [Jaycar WW-4020] will cover aprox 10 sets.
• 0.63mm [B&S 22] Enamelled Copper Winding Wire. [Jaycar WW-4018] will cover aprox 20 sets.
• 12 Volt 10 Amp Power cable.
• 1 of 100K ohm potentiometer. Jaycar # RT-4366
Philips FM92E Conversion to 6 Meters: Version 3.9 Page 13
To Next Page
Loading...
