Notes:
– For recording, use only tape of IEC type I (normal
tape) or IEC type II (Chrome).
– The tape is secured at both ends with leader tape. At
the beginning and end of tape, nothing will be
recorded for six to seven seconds.
– The recording level is set automatically, regardless of
the position of VOLUME, DBB, Incredible Surround or
DPL. Dolby B NR can be selected for Tuner or CD
recording.
– To prevent accidental recording, break out the tab on
the left shoulder of the tape side you want to protect.
– If “
CHECK TAPE
” is displayed, the protection
tab has been broken. Put a piece of clear adhesive
tape over the opening. Do not cover the Chrome tape
detection hole when covering the tab opening.
One Touch Recording
• For One Touch Recording, as soon as you press
RECORD, the current source (CD, TUNER, TAPE 1 or
AUX•DVD) will be recorded on tape deck 2
1 Load a blank tape in tape deck 2.
2 Press RECORD â.
™ The REC flag is displayed.
3 Press STOP Ç to stop recording.
Note:
– When you press RECORD at TAPE 2 mode,
“
SELECT SOURCE
” will be displayed. One
Touch Recording is not possible at TAPE 2 mode.
Recording from other sources
(only on tape
deck 2)
1 Press TAPE to select tape deck 2 .
2 Load a blank tape into tape deck 2 with the open side
downward.
3 Press SIDE on the remote control to select the
recording side.
™ The FRONT or BACK flag will be displayed,
depending on the side selected.
4 Press REV MODE to select the playback mode
(
åå
or
∂∂
).
5 Press DOLBY NR to record with Dolby NR
(except in
TAPE 1 mode)
.
6 Press CD, TUNER, TAPE 1 or AUX•DVD.
• Start playback of the selected source.
7 Press RECORD â to start recording.
™ The REC flag is displayed.
8 Press STOP Ç to stop recording.
Notes:
– Only
åå
or
∂∂
mode is available during recording.
– During recording, it is not possible to listen to
another sound source.
IT IS RECOMMENDED THAT YOU SWITCH OFF
DOLBY PRO LOGIC WHEN RECORDING.
24
English
RECORDING
To Next Page
Loading...
