Tuning to radio stations
1 Press TUNER to select TUNER mode.
™ “TUNER” will be displayed.
A few seconds later, the current frequency or the
radio station name if available will be displayed.
2 Press TUNER (BAND) again to select the desired
waveband : FM, MW or LW.
3 Press TUNING à or á for more than one second,
then release.
™ The display will show ‘SEARCH’ until a station
with sufficient signal strength is found.
• Repeat this procedure until the desired station is
reached.
• To tune to a weak station, briefly press TUNING à
or á until the display shows the desired frequency
and/or when the best reception has been obtained.
Storing Preset Stations
You can store up to 40 stations in the memory. When a
preset radio station is selected, the preset number
appears next to the frequency on the display.
Automatic programming
1 Press TUNER.
2 Press TUNER (BAND) again to select the desired
waveband : FM, MW or LW.
3 Press PROGRAM for more than one second.
™ PROGRAM flag start flashing and ‘AUTO’ will be
displayed.
™ Every available radio station for the selected
waveband will be stored automatically. The
frequency and preset number will be displayed
briefly.
™ The system will stop searching when all the
available radio stations are stored or when the
memory for 40 preset radio stations is used.
™ The system will remain tuned to the last stored
preset radio station.
• Repeat the above procedure to store other preset
stations for the other waveband. Remember to select
the next available preset number before proceeding. If
not, some of the preset radio stations may be erased.
Notes:
– You can cancel the automatic programming by
pressing PROGRAM or STOP Ç (on the system
only).
– If you want to reserve a section of preset numbers,
for example preset numbers 1 to 9, select preset 10
before starting automatic programming: now only the
preset numbers 10 to 40 will be programmed.
Manual programming
1 Press TUNER.
2 Press TUNER (BAND) to select the desired waveband
: FM, MW or LW.
3 Press PROGRAM for less than one second.
™ The PROGRAM flag starts flashing.
™ The next available preset number will be displayed
for selection.
4 Press TUNING à or á to tune to the desired
frequency.
• If you wish to store the radio station to another
preset number, press PRESET 4 or 3 to select the
desired preset number.
5 Press PROGRAM again.
™ PROGRAM flag will stop flashing, and the station
will be stored.
• Repeat the above procedure to store other preset
stations.
18
English
TUNER
To Next Page
Loading...
