Important:
Before you begin operating the system, complete
the preparation procedures.
Demonstration mode
The system has a demonstration mode that shows the
various features offered by the system.
Whenever the
system is switched on from the wall socket, the
demonstration mode will start automatically.
Notes:
– During demonstration mode, if you press any source
(or standby-on) button, the system will switch to the
respective (or standby) mode.
– When the system is switched to standby mode, 5
seconds later, the demonstration mode will begin
again.
To cancel demonstration mode
• Press and hold STOP Ç
(on the
system only)
for
3 seconds
to stop
the demonstration.
™ The demonstration mode will be
switched off permanently.
™ The system will switch to standby mode. About 2
seconds later, the system will go into an economy
power conservation mode ( < 2 watts ).
Switching the system ON
• Press STANDBY•ON
(on the system only),
CD,
TUNER, TAPE or AUX•DVD.
You can also switch on the system by pressing any one
of the 3 CD DIRECT PLAY buttons.
Switching the system to standby mode
• Press STANDBY•ON again.
™ The system will switch to standby mode. About 2
seconds later, the system will go into an economy
power conservation mode ( < 2 watts ).
™ The display will not be lighted except the STOP Ç
button on the system.
Selecting the Source
• Press the respective source selection button: CD,
TUNER, TAPE or AUX•DVD.
™ The display indicates the selected source.
Note:
– For an external source, make sure that you have
connected the audio left and right out terminals of
the external equipment (TV, VCR, Laser Disc or DVD
player) to the AUX IN terminals.
Sound Control
Volume Adjustment
Rotate VOLUME right or left to increase or decrease the
sound level.
For Personal Listening
Connect the headphones plug to the n socket at the
front of the system. The speakers will be muted and DPL
mode will be switched off.
13
English
OPERATING THE SYSTEM
To Next Page
Loading...
