Warning! Under no circumstances should you try
to repair the system yourself, as this will
invalidate the warranty.
• If a fault occurs, check the points listed below before
taking the system for repair.
• Should any problems persist after you have made
these checks, consult your nearest dealer or service
center.
CD Player Operation
“NO DISC” is displayed.
• The disc is inserted upside down.
™
Place CD with printed side up.
• Moisture condensation at the lens.
™
Wait until lens has adjusted to normal room
temperature.
• There is no disc in the CD tray.
™
Insert a CD.
• The CD is dirty, badly scratched or warped.
™
Clean or replace the CD.
• The CD lens is dirty or dusty.
™
See section under Maintenance.
Radio Reception
Poor radio reception
• The signal strength is too weak.
™
Adjust the antenna.
• The TV or VCR is too close to the stereo system.
™
Separate the stereo system from the TV or VCR.
™
Connect an external antenna for better reception.
“NO RDS TEXT” is displayed.
• RDS text message is not available.
™
Select another RDS station.
Tape Deck Operation
“RECORDING ACTIVE” is displayed.
• A recording is in progress.
™
Stop the recording or wait until it is finished.
“TAPE DUBBING ONLY” is displayed.
• Tape dubbing is only possible in tape mode.
™
Switch source to tape mode.
Recording or playback cannot be made or there is
a decrease in audio level.
• Dirty tape heads, capstans or pressure rollers.
™
See section on tape deck maintenance.
• Magnetic build-up in the record/playback head.
™
Use demagnetizing tape.
General
System switches to standby mode automatically.
• The system is operating in an extremely hot
environment or internal heat build-up is high.
™
This is not a malfunction. The system incorporates a
built-in safety feature that prevents overheating.
™
Let the system cool down, then switch on again.
System does not react when any button is pressed.
• Electrostatic discharge.
™
Press STANDBY-ON to switch the unit off; Remove
the AC power plug from the wall outlet, then
reconnect and switch on the system again.
No or poor sound.
• Volume is not turned up.
™
Adjust Volume.
• The headphones are connected.
™
Disconnect the headphones.
• Speakers are not connected or are connected
wrongly.
™
Check that the speakers are connected correctly.
™
Make sure that the stripped speaker wire is clamped.
Reversed left and right sound.
• Speakers are connected wrongly.
™
Check the speaker connections and location.
Lack of bass sound or apparently imprecise
physical location of musical instruments.
• Speakers are connected wrongly.
™
Check the speaker connection for proper phasing,
red/black wires to red/black terminals.
Remote control has no effect on the system.
• The distance to the system is too large.
™
Reduce the distance.
• Batteries are inserted incorrectly.
™
Insert the batteries with their polarities (+/– signs) as
indicated.
• Batteries are exhausted.
™
Replace the batteries.
• Wrong source is selected.
™
Select the source (CD, TUNER, etc.) before pressing
the function button, (PLAY, PREV/NEXT, etc.).
Timer not working.
• Timer is not switched on.
™
Press TIMER ON/OFF on remote control to switch on
the timer.
• Dubbing/recording is in progress.
™
Stop dubbing/recording.
System display features automatically and buttons
flashing continuously.
• Demo mode is switched on.
™
Press and hold STOP Ç for 3 seconds to switch off
the demo.
“UNPLUG HEADPHONE” is displayed.
• Headphones is connected.
™
Disconnect the headphones.
27
English
TROUBLESHOOTING
To Previous Page
Loading...
