18
English
3139 116 19311
RECORDING CLOCK
5 Press STOP•OPEN on tape deck 1 and
tape deck 2 to stop dubbing.
Notes:
– At the end of side A, flip the tapes to
side B and repeat the procedure.
– Dubbing of tapes is only possible from
tape deck 2 to tape deck 1.
– To ensure good dubbing, use tapes of
the same length.
Recording from other sources
(only on tape deck 1)
1 Load a blank tape into tape deck 1.
2 Press CD, TUNER or AUX.
• Start playback of the selected source.
3 Press RECORD on tape deck 1 to start
recording.
™ The REC starts flashing.
4 Press PAUSE to interrupt recording.
5 Press STOP•OPEN on tape deck 1 to
stop recording.
Note:
– During recording, it is not possible to
listen to another sound source.
View Clock
You can view the clock (if it is set) if the
system is in Standby mode or when any
sound source is selected (CD, TUNER, etc.).
The clock will be displayed for about seven
seconds.
• Press CLOCK•TIMER briefly.
™ “10:38 PM or 22:38” (the current
time) will be displayed depending on
whether you have selected 12- or 24-
hour mode.
™ “--:--” will be displayed if the
clock is not set.
Clock Setting
The clock can be set in either 12- or 24-
hour mode, e.g. “12:00 AM“ or
“00:00“. Before setting the clock, you
must be in the View Clock mode.
1 Press CLOCK•TIMER to select clock
mode.
2 Press PROGRAM to select 12- and 24-
hour mode.
™ If 12-hour mode is selected,
“12:00“ starts flashing and the AM
lights up.
™ If 24-hour mode is selected,
“00:00” starts flashing.
3 Set the hour with à or á on the
system.
4 Set the minute with í or ë on the
system.
5 Press CLOCK•TIMER again to store the
setting.
To Next Page
Loading...
