13
English
Sound Control
VOLUME ADJUSTMENT
Press MASTER VOLUME 3 or 4 to increase
or decrease the sound level.
For Personal Listening
Connect the headphones plug to the n socket
at the front of the system. The speakers will be
muted.
DIGITAL SOUND CONTROL (DSC)
The DSC feature enables you to enjoy special
sound effects that have preset equalizer settings,
providing the best music reproduction.
● Press DSC to select OPTIMAL, JAZZ, ROCK or
TECHNO.
➜ “OPTIMAL, JAZZ, ROCK or TECHNO” and
the respective flag will be displayed.
Note:
– When "OPTIMAL" sound is selected DBB will
be switched on automatically.
DYNAMIC BASS BOOST (DBB)
The DBB mode enhances the bass response.
● Press DBB to switch on bass response.
➜ “DBB ON” and the DBB flag will be displayed.
To switch off DBB
● Press DBB again.
➜ “DBB OFF” will be displayed.
Note:
– Some discs or tapes might be recorded in high
modulation, which causes a distortion at high
volume. If this occurs, switch off DBB or reduce the
volume.
MUTE (only on remote control)
This feature allows you to temporarily switch off the
sound of the system without switching off the
system when you require a moment of silence.
● Press MUTE on the remote control to switch
off the sound.
➜ "MUTE" and the MUTE flag will be displayed.
● Press MUTE again on the remote control or
increase the MASTER VOLUME to switch on
the sound.
Operating the System
14
English
Compact Disc
Warning!
1)
This system is designed for conventional
discs. Do not use any accessories such as
disc stabilizer rings or disc treatment sheets,
etc., which may damage the disc
mechanism.
2)
Do not load more than one disc into each
tray.
3)
When the CD changer is loaded with discs,
do not turn over or shake the system. This
may jam the changer.
You may load three discs in the CD
changer for continuous playback without
interruption.
Discs for playback
This system can play all digital audio disc,
finalized digital audio CD-Recordable and
finalized digital audio CD-Rewritable format
discs.
Loading the CD Changer
1
Press CD to select CD mode.
2
Press OPEN•CLOSE.
➜ The CD changer tray slides out.
3
Load a disc with the printed side up in the right
tray.
¶ You can load another disc in the left tray.
¶ To load the third disc, press the DISC
CHANGE button.
➜ The CD changer tray will rotate until the
empty tray is ready for loading.
4
Press OPEN•CLOSE to close the CD changer
tray.
➜ A lit on the respective CD numeric flag
indicates that its corresponding disc(s) is loaded
in the disc tray.
Note:
–To ensure good system performance, wait until
the CD changer completely reads the disc(s) before
proceeding.
Disc Direct Play
¶ You can play a disc directly by pressing the
DISC 1, DISC 2 or DISC 3 button. The CD
player will stop at the end of playback of the
selected disc.
➜ The corresponding CD numeric flag starts to
flash.
To Next Page
Loading...
