Philips FW-C100 - Operating the System; Plug and Play; Demostration Mode

11
English
3139 115 20281
Operating the System
DIGITAL SOUND CONTROL
STANDBY
-
ON
PROGRAM CLOCK • TIMER
MASTER
VOLUME
MINI HIFI SYSTEM
CD1 • 2 • 3
TAPE 1 • 2
PRESET
▲
▲
TUNING
▲ ▲ ▲ ▲
STOP• CLEAR
SEARCH
PLAY• PAUSE PREV NEXT
3 CD ROTARY CHANGER SYSTEM
•
CD REWRITABLE COMPATIBLE
•
CD SYNCHRO RECORDING
•
VIDEO
DYNAMIC BASS BOOST
BAND
CD
TUNER TAPE
AUX
O
P
T
I
M
A
L
J
A
Z
Z
R
O
C
K
T
E
C
H
N
O
DSC
DEMO STOP
Important:
Before you operate the system, complete
the preparation procedures.
Plug and Play
The system provides PLUG and PLAY feature
that allows you to store all available radio
stations automatically upon power up. If PLUG
and PLAY has been installed beforehand, it
will go to standby or demonstration mode
after 5 seconds.
1 Press and hold PLAY (on the system only) for 5
seconds; when the system is in standby or
demonstration mode.
● If the PLUG and PLAY has not been installed
before, you can access this feature by switching
on the system from the main power outlet.
➜ “AUTO INSTALL - PRESS PLAY” will be
displayed.
2 Press PLAY to start installation.
➜ “INSTALL” will be displayed and followed by
“TUNER” and then "AUTO".
➜ The PROGRAM starts flashing.
➜ PLUG and PLAY will start searching for all
radio stations on FM band and then followed by
radio stations on MW and LW bands
respectively.
➜ All available radio stations with sufficient signal
strength will be stored. Up to 40 presets may be
stored.
➜ The last preset radio station will appear on
the display when PLUG and PLAY is completed.
● To exit without storing the PLUG and PLAY,
press Ç button (on the system only).
Notes:
– PLUG and PLAY will be reinitiated again during
the next power up if :
i) PLUG and PLAY installation was not
completed.
ii) No stereo frequency being detected during
PLUG and PLAY, "CHECK ANTENNA" will be
displayed.
– You can store any radio stations manually or
automatically after PLUG and PLAY.
– When PLUG and PLAY is used, all previously
stored radio stations will be replaced.
– During PLUG and PLAY, if no button is pressed
within 15 seconds, the system will go to
demonstration mode (if demonstration mode is
enable)
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the system.
To disable the demonstration mode
● Press and hold Ç (on the system only) for 5
seconds when the system is in demonstration
mode.
➜ "DEMO OFF" is displayed.
➜ The system will switch to standby mode.
2
21
3
TUNERTAPE 1/2CD
SLEEP AUXDIM
DSC DBB
MUTE
REPEAT
PAUSE
SHUFFLE
Å
CD DIRECT
VOLUME
á
à
ë
í
É
Ç
pg 01-27/C100/22-Eng 12/6/00, 3:18 PM11