19
English
Ta p e
Loading a tape
1
Press STOP•OPEN.
2
The tape deck door opens.
3
Load the tape with the open side downward and
the full spool to the left.
4
Close the tape deck door.
Ta pe Playback
1
Press TAPE to select TAPE mode.
➜ "TAPE" will be displayed.
2
Load the tape into the selected tape deck.
3
Press PLAYÉ to start playback.
¶ To interrupt playback, press PAUSE.
¶ To resume playback, press PAUSE again.
4
Press STOP•OPEN to end playback.
Rewind/Fast Forward
When playback is stopped
1
You can rewind or fast forward a tape by
pressing à or á , respectively.
➜ The tape will stop automatically at the end of
rewinding or fast forwarding.
2
Press STOP•OPEN to stop rewinding or fast
forwarding.
20
English
Continuous Playback From Tape
Deck 2 to Tape Deck 1
1
Press TAPE to select TAPE mode.
2
Load the tapes in tape deck 1 and 2.
3
Press PLAY 2 on tape deck 2.
4
Press PAUSE on tape deck 1.
5
Press PLAY 2 on tape deck 1.
➜ Playback will begin with tape deck 2 and will
continue with tape deck 1 when playback on
tape deck 2 ends.
6
Press STOP•OPEN if you want to stop
playback before the end of the tape in tape deck
1 or tape deck 2.
Notes:
– During rewinding or fast forwarding of a tape, it
is also possible to listen to another source (e.g. CD,
TUNER or AUX).
– Before playing a tape, check and tighten slack
tape with a pencil. Slack tape may get jammed or
may burst in the mechanism.
– C-120 tape is extremely thin and is easily
deformed or damaged. It is not recommended for
use in this system.
– Store the tapes at room temperature and do not
put them too close to a magnetic field (for
example, a transformer, TV or speaker).
.
Ta p e
To Next Page
Loading...
