21
English
3139 116 19551
REPEAT
SHUFFLE
PROGRAM
TIMER
STEREO
FM
BACK
HSD
LW
MW
AM
T.A.
NEWS
SOUND NAVIGATION
DUB
(HSD)
REC
TAPE 2TAPE 1
OPEN OPEN
MINI HIFI SYSTEM
FRONT
60Hz
500Hz
250Hz
1KHz
2KHz
4KHz
8KHz
REC
INCREDIBLE
SURROUND
DYNAMIC BASS
BOOST
TAPECD
PROG
CLOCK/
TIMER
TUNER AUX
PRESET
▲
▲
STOP•CLEAR
SEARCH • TUNING
PLAY
PAUSE PREV NEXT
CD1 • 2 • 3
CDR/VIDEO
BAND
TAPE 1 • 2
DIGITAL
SOUND CONTROL
A. REV
NEWS/TA
RDS
SIDE
MIC
MIC
LEVEL
Notes:
– It is not possible to change tape side
during recording.
– If you do not intend to record via the
microphone, unplug the microphone to
avoid accidental mixing with other
recording source.
– For recording, use only tape of IEC type I
(normal tape) or IEC type II (Cr0
2
).
– The tape is secured at both ends with
leader tape. At the beginning and end of
tape, nothing will be recorded for six to
seven seconds.
– The recording level is set automatically,
regardless of the position of Volume,
DBB, Incredible Surround or DSC.
– To prevent accidental recording, break
out the tab on the left shoulder of the
tape side you want to protect.
– If “
CHECK TAPE
” is displayed, the
protection tab has been broken. Put a
piece of clear adhesive tape over the
opening. Do not cover the Cr0
2
tape
detection hole when covering the tab
opening.
Digital Recording via Digital
Out
For CD digital recording, please refer to the
Instructions Manual of the CD Recorder,
digital audio equipment, etc.
RECORDING
Recording from other sources
(only on tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load a blank tape into tape deck 2 with
the open side downward.
3 Press í or ë to select the recording
tape side
(see Tape Side under TAPE
section)
.
4 Press CD, TUNER or AUX.
• Start playback of the selected source.
5 Press REC to start recording.
™ The REC starts flashing.
6 Press Ç to stop recording.
Notes:
– Only
åå
åå
å
or
∂∂
∂∂
∂
mode is available
during recording .
– During recording, it is not possible to
listen to another source.
Dubbing tapes
(from tape deck 1 to
tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load the prerecorded tape into tape
deck 1 with full spool to the left and a
blank tape into tape deck 2 with full
spool aside.
3 Press í or ë to select the recording
tape side
(see Tape Side under TAPE
section)
.
pg 01-26/C55/22-Eng new 3/6/00, 11:43 AM21
To Next Page
Loading...
