22
English
3139 116 19551
RECORDING CLOCK
4 Press DUB (HSD)
once
for normal
speed dubbing or
twice
(within 2
seconds)
for high speed dubbing.
™ "NORMAL" (normal speed) or
"FAST" (high speed) will be
displayed, followed by "DUB" with
"< or >" scrolling left or right
depending on the tape side selected.
™ The HSD appears on the display
during high speed dubbing.
• Dubbing will start immediately.
™ The REC starts flashing.
5 Press Ç to stop dubbing.
Notes:
– Only
å å
å å
å
mode is available during
dubbing.
– At the end of side A, flip the tapes to
side B and repeat the procedure.
– Dubbing of tapes is only possible from
tape deck 1 to tape deck 2.
– To ensure good dubbing, use tapes of
the same length.
– During high speed dubbing in Tape
mode, the sound is reduced to a low
volume.
– You can listen to another source while
dubbing.
CD Synchro Start Recording
1 Load a blank tape into tape deck 2 and a
disc into a disc tray.
2 Press CD to select CD mode.
View Clock
You can view the clock (if it is set) if the
system is in Standby mode or when any
sound source is selected (CD, TUNER, etc.).
The clock will be displayed for about 7
seconds.
• Press CLOCK/TIMER briefly.
™ "PM 10:38 or 22:38" (the
current time) will be displayed
depending on whether you have
selected 12- or 24-hour mode.
™ "--
::
::
:--" will be displayed if the
clock is not set.
Clock Setting
The clock can be set in either 12- or 24-
hour mode, e.g. "AM 12:00" or
"00:00". Before setting the clock, you
must be in the View Clock mode.
1 Press CLOCK/TIMER to select clock
mode.
2 Press PROG
(on the system only)
to
select 12- and 24- hour mode.
™ If 12-hour mode is selected, "AM
12:00" starts flashing.
™ If 24-hour mode is selected,
"00:00" starts flashing.
3 Set the hour with␣ à or á on the
system.
4 Set the minute with␣ í or ë on the
system.
SHUFFLE
PROGRAM
FM
STEREO
BACK
HSD
REPEAT
REC
LW
MW
AM
T.A.
NEWS
SOUND NAVIGATION
DUB
(HSD)
REC
MINI HIFI SYSTEM
TIMER
FRONT
60Hz
500Hz
250Hz
1KHz
2KHz
4KHz
8KHz
INCREDIBLE
SURROUND
DYNAMIC BASS
BOOST
TAPECD
PROG
CLOCK/
TIMER
NEWS/TA
TUNER AUX
PRESET
▲
▲
STOP•CLEAR
SEARCH • TUNING
PLAY
PAUSE PREV NEXT
CD1 • 2 • 3
CDR/VIDEO
BAND
TAPE 1 • 2
DIGITAL
SOUND CONTROL
A. REV
STANDBY
ON
RDS
SIDE
MIC
MIC
LEVEL
MIC
• You can program the tracks in the order
you want them to be recorded (see
Programming Tracks). If not, select the
disc by pressing CD (CD 1•2•3) and the
tracks are recorded according to the
order on the selected disc.
3 Press REC to start recording.
™ The REC starts flashing.
• CD will start playback automatically.
4 Press Ç to stop recording.
Recording the mixed sound /
One Touch Recording
• During microphone mixing, you can
record the mixed sound on a tape in
tape deck 2 except dubbing mode.
• For One Touch Recording, as soon as you
press REC, the current source (CD,
TUNER or AUX) will be recorded on tape
deck 2.
1 Load a blank tape in tape deck 2.
2 Press REC to start recording.
™ The REC starts flashing.
3 Press Ç to stop recording.
Note:
– When you press RECORD while in TAPE
mode, "
SELECT SOURCE
" will be
displayed. One Touch Recording is not
possible in TAPE mode.
pg 01-26/C55/22-Eng new 3/6/00, 11:43 AM22
To Next Page
Loading...
