Connections
AUDIO IN
R L
VIDEO
IN
TO TVINT IN
CH3 CH4
RF coaxial cable to TV
Back of RF Modulator
(example only)
Antenna or
Cable TV signal
LINE
OUT
(CVBS)
D
D
D
P
U
UU
(
(
IMPORTANT!
– If your TV set only has a single
Antenna In jack (or labeled as 75 ohm or
RF In), you will need a RF modulator in
order to view the DVD playback via TV.
See your electronics retailer or contact
Philips for details on RF modulator
availability and operations.
Using an accessory RF modulator
Use the composite cable (yellow) to connect the
system’s CVBS jack to the video input jack on
the RF modulator.
Use the RF coaxial cable (not supplied) to
connect the RF modulator to your TV’s RF jack.
Television
Y
AUX/
TV
IN
LINE
OUT
(CVBS)
D
D
D
P
U
UU
(
(
IMPORTANT!
– If the picture is distorted, check the
Video Output setting. Make sure it is set
to ‘S-Video’. See page 31, Using the Setup
Menu – Setting the video out.
Using S-Video In jack
Use the S-Video cable (not supplied) to connect
the system’s S-VIDEO OUT jack to the S-
Video input jack (or labeled as Y/C or S-VHS) on
the TV set.
To listen to TV channels through this system, use
the audio cables (white/red) to connect AUX/
TV IN (L/R) jacks to the corresponding
AUDIO OUT jacks on the TV set.
Connections
Step 4: Connecting FM/MW
antennas
DIN OUT
MW ANTENNA FM ANTENNA
FM
antenna
MW
antenna
fix the claw
into the slot
Connect the supplied MW loop antenna to the
MW jack. Place the MW loop antenna on a
shelf or attach it to a stand or wall.
Connect the supplied FM antenna to the FM
jack. Extend the FM antenna and fix its end to
the wall.
For better FM stereo reception, connect an
outdoor FM antenna to the FM ANTENNA
terminal.
MW ANTENNA FM ANTENNA
Notes:
– Adjust the position of the antennas for optimal
reception.
–Position the antennas as far as possible from
your TV set, VCR or other radiation sources to
prevent unwanted interference.
Step 5: Connecting the power
cord
~ AC MAINS
AUDIO
OUT
Pr/Cr
Pb/Cb
Y
S-VIDEO
IN
VIDEO IN
COMPONENT
VIDEO IN
Power Outlet
DIN OUT
SUBWOOFER
OUT
After everything is connected properly,
plug in the AC power cord to the power
outlet.
Never make or change any connection with the
power switched on.
On the DVD Mini Hi-Fi System
“AUTO INSTALL-PRESS PLAY”may appear
on the display panel. Press 2; on the front panel
to search and store all available radio stations or
press 9 to exit (See page 35, Tu ner Operations-
Presetting radio stations).
If your system is equipped with a Voltage
Selector, set the VOLTAGE SELECTOR
to the local power line voltage.
VOLTAGE
NOT FOR ALL
To Next Page
Loading...
