Connections
Connecting a VCR or
cable/satellite box
AUDIO
OUT
Pr/Cr
Pb/Cb
Y
S-VIDEO
IN
VIDEO IN
COMPONENT
VIDEO IN
ANT IN
TO TV
VCR or
Cable/Satellite
Box
2
4
1
3
3
AUX/
TV
IN
LINE
OUT
(CVBS)
D
D
D
P
U
UU
(
(
Viewing and listening to playback
1 Connect the VCR or Cable/Satellite Box to the
TV system as shown.
2 Connect the system’s AUX/TV IN (R/L) jacks to
the AUDIO OUT jacks on the VCR or Cable/
Satellite box.
Before starting operation, press AUX/TV on
the remote control to select “AUX” in order to
activate the input source.
Using the VCR for recording DVDs
Some DVDs are copy-protected. You cannot
record or dub protected discs using a VCR.
3 Connect the system’s CVBS jack to the VIDEO
IN jack on the VCR.
4 Connect the system’s LINE OUT (R/L) jacks
to the AUDIO IN jacks on the VCR. This will
allow you to make analog stereo (two channel,
right and left) recording.
To v i e w D VD playback while recording
Yo u must connect the system to your TV system
using the S-VIDEO (as shown above) or the
Component (Pr Pb Y) video connection.
Connecting digital audio
equipment
DIGITAL IN
AUX/
TV
IN
LINE
OUT
(CVBS)
D
D
D
P
U
UU
(
(
Recording (digital)
Connect the system’s DIGITAL OUT jack to the
DIGITAL IN jack on a digital recording device
(DTS-Digital Theater System compatible, with a
Dolby Digital decoder, for example).
Before operation, set the DIGITAL OUTPUT
according to the audio connection. (See page 31,
Using the Setup Menu – Setting the digital
output).
To Next Page
Loading...
