Philips FW- FW-C399 - Basic System Functions; Plug and Play Radio Station Setup

14
English
3139 115 21071
Basic Functions
CD1 • 2 • 3FM•AM
TAPE 1 • 2
VIDEO/ CDR
STOP•CLEAR
SEARCH •TUNING
RECORD
PLAY• PAUSE PREV NEXT
PRESET
CLOCK•TIMER DUBBING A. REPLAY PROGRAM
▲
▲
SOUND NAVIGATION - JOG
VOLUME
DISC 1
DISC 2
DISC 3
CD TUNER TAPE AUX
D
B
B
V
E
C
D
S
C
I
N
C
R
E
D
I
B
L
E
S
U
R
R
O
U
N
D
DEMO STOP
ALBMUTE TITLEDIM 1 NEWS
STANDBY-ON
ECO
POWER
DIM MODE
2
21
3
TUNERTAPE 1/2CD
MAXAUXINC.SURR.
DSC VEC
DBB 1/2/3
REPEAT
SLEEP
SHUFFLE
CD DIRECT
VOLUME
á
à
ë
í
É
Ç
Å
JOG
IMPORTANT!
Before you operate the system, complete
the preparation procedures.
Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
First time setup/power up
1 When you turn on the main supply, "AUTO
INSTALL - PRESS PLAY" is displayed.
2 PressÉÅ on the system to start installation.
➜ "INSTALL" is displayed, followed by "TUNER"
and "AUTO".
➜ PROG starts flashing.
➜ All available radio stations with sufficient signal
strength will be stored automatically, starting
from FM and followed by AM band.
➜ When all the available radio stations are
stored or the memory for 40 presets are used,
the last preset radio station will be played.
To reinstall Plug and Play
1 In standby or demonstration mode, press and
holdÉÅ on the system until "AUTO INSTALL
- PRESS PLAY" is displayed.
2 PressÉÅ again to start installation.
➜ All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
● Press Çon the system.
➜ If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the main supply again.
Notes:
– When the power is turned on, the disc tray may
open and close to initialize the system.
– If no stereo frequency is detected during
Plug and Play, "CHECK ANTENNA" will be
displayed.
– During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode.
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the system.
To activate the demonstration
● In standby mode, press and holdÇon the
system until "DEMO ON" is displayed.
➜ The demonstration will begin.
To deactivate the demonstration
● Press and holdÇon the system until
"DEMO OFF" is displayed.
➜ The system will switch to standby mode.
pg 001-031/C399/37-Eng 11/28/01, 1:34 PM14