3139 115 20042
10
English
CONTROLS
for CLOCK ..... to set the minute
(on
the system only)
.
) MIC LEVEL
– to adjust the mixing level for karaoke
or microphone recording.
¡ MIC
– to connect microphone jack.
™ VOLUME
– to increase or decrease the volume.
£ DYNAMIC BASS BOOST (DBB)
– to select a bass boost level or to
switch off bass boost.
≤ OPEN
– to open tape deck 2.
∞ TAPE DECK 2
§ TAPE DECK 1
≥ OPEN
– to open tape deck 1.
• OSD (ON SCREEN DISPLAY)
– to switch on or off the on screen
display on the TV screen.
ª ZOOM
– to enlarge a still picture on the TV
screen
(for VCD operation only)
.
º VOCAL
– to fade out the vocal of the original
song during VCD playback or to switch
between mono or stereo mode during
audio disc playback
(for VCD operation
only)
.
⁄ KEY CONTROL ( I È i )
– to change the key to suit your vocal
range
(for VCD operation only)
.
I ................. to decrease vocal key
level.
È .................... to restore vocal key to
original setting.
i ................... to increase vocal key
level.
¤ ECHO -/+
– to adjust the echo level for karaoke
(for VCD operation only)
.
‹ RESUME
– to continue playback again from
where you have stopped. Only when
PBC mode is switched off
(for VCD
operation only)
.
› SLOW
– to watch a VCD at a slower speed.
There are 3 modes of selection
(for
VCD operation only)
.
fi A - B
– to playback a certain scene or passage
of a VCD/CD repeatedly.
fl DIGEST
– to scan through a VCD or a particular
track. There are 4 modes of selection
(for VCD operation only)
.
‡ REPEAT
– to repeat a disc track or the current
disc.
° DIGIT 0 – 9
(numbers consisting more than two
figures must be keyed in within 2
seconds.)
for VCD with PBC on ..........................
to select an entry level.
for VCD/CD/MP3-CD…to key in a disc
track to start playback
or
...................... to select another track
during playback or
...................... to select a track for
programming.
· B
– to switch the system to standby mode.
Notes for remote control:
– First select the source you wish to
control by pressing one of the
source select keys on the remote
control (e.g. VCD, TUNER, etc.).
– Then select the desired function
(
É
,
í
,
ë
, etc.).
pg 01-28/V55/21-En 6/8/01, 9:11 AM10
To Next Page
Loading...
