12
English
Connections
IMPORTANT!
– If the picture is distorted, check the
Video Output setting. Make sure it is set
to ‘S-Video’. (See Setting video
preference).
Using S-Video In jack
● Use the S-Video cable (not supplied) to connect
the system’s S-VIDEO OUT jack to the S-
Video input jack (or labeled as Y/C or S-VHS) on
the TV set.
Connecting Digital out
IMPORTANT!
To select ALL or PCM 48 KHz for Digital
Out, please see Setting Digital Out.
Digital out selection enables you to specify the
type of digital output suitable for our amplifier or
receiver.
● Select ALL if you have connected the digital
output to a multifunctional decoder receiver.
● Select PCM 48K if the external component is
incapable of processing 96KHz digital signal input,
and then convert the standard signal with the
sampling rate of 48KHz.
DIGITAL IN
pg001-pg032_FWD17_21-Eng 2005.5.25, 2:32 PM12
To Next Page
Loading...
