Philips FWM377/12 - Basic Functions; System Power and Standby Modes; Display and Volume Adjustment

English
15
Basic Functions
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the system.
To activate the demonstration
● In standby mode, press and hold STOPÇ on
the system for 5 seconds to switch to
demonstration.
To deactivate the demonstration
● Press and hold STOPÇ on the system for 5
seconds to switch to standby mode.
Switching the system on
● Press ECO POWER/STANDBY-ON 2.
➜ The system will switch to the last selected
source.
● Press DISC (or DISC 1/2/3, CD 1/2/3),
TUNER, AUX•TAPE (or AUX, TAPE) or
USB.
➜ The system will switch to the selected source.
● Press OPEN•CLOSE or DISC CHANGE.
➜ The system will switch to the disc source and
the disc tray will open.
In Eco Power standby mode
● Press ECO POWER/STANDBY ON/B to
switch on the last selected source.
● Press DISC (or DISC 1/2/3, CD 1/2/3),
TUNER, AUX•TAPE (or AUX, TAPE) or
USB.
Switching the system to standby
mode
In demonstration mode
● Press and hold Ç on the system.
In any other source mode
● Press ECO POWER/STANDBY ON B.
➜ The clock will appear on the display when the
system is in standby mode.
Switching the system to Eco
Power mode (< 1 Watt)
● Press and hold ECO POWER/STANDBY
ON/B until “ECO POWER” is displayed.
➜ The display screen will go blank.
➜ The low power ECO POWER LED will be
lighted.
Note:
– If you have not deactivated the demonstration, it
will resume five seconds after the system switches
to Eco Power standby or standby mode.
Power-saving automatic standby
As a power-saving feature, the system will
automatically switch to Standby mode if you do
not press any buttons within 15 minutes after a
disc has stopped playing.
Dim mode
You can select the desired brightness for the
display.
● In any source mode (except standby mode),
press DIM repeatedly to select DIM 1, DIM 2,
DIM 3 or DIM OFF display mode.
➜ DIM is shown, except for DIM OFF mode.
Volume control
Adjust MASTER VOLUME to increase (turn
knob clockwise or press VOL + on the remote)
or decrease (turn knob anti-clockwise or press
VOL - on the remote) the sound level.
To listen through the headphones
● Connect the headphones plug to
the n socket at the front of the
system.
➜ The speakers will be muted.
To switch off the volume
temporarily
● Press MUTE on the remote control.
➜ Playback will continue without sound and
"MUTE" is displayed.
● To restore the volume, press MUTE again or
increase the volume level.
pg001-034_FWM377_12_Eng 2007.2.4, 16:3815