30
English
Clock/Timer
Clock setting
The system only supports 24-hour time mode.
1 In standby or view clock mode, press
CLOCK•TIMER on the remote control once.
In other source mode, press CLOCK•TIMER
twice.
2 Press à or á repeatedly to set the hour.
3 Press í or ë repeatedly to set the minute.
4 Press CLOCK•TIMER again to store the
setting.
➜ The clock starts working.
To exit without storing the setting
● Press STOP Çon the system.
Notes:
– The clock setting will be cancelled when the
power cord is disconnected or if a power failure
occurs.
– During clock setting, if no button is pressed
within 30 seconds, the system will exit clock setting
mode automatically.
Timer setting
The system can switch on to CD, TUNER or
USB mode automatically at a preset time, serving
as an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that the
clock is set correctly.
1 Press and hold CLOCK•TIMER on the
remote control for more than two seconds to
select timer mode.
➜ The last timer setting starts flashing.
➜ The selected source will be lighted.
2 Press DISC (or DISC 1/2/3, CD 1/2/3),
TUNER or USB to select the desired source.
● Before setting timer, make sure the music source
has been prepared.
CD – Load the disc(s). To start from a specific
track, make a programme (refer to “CD
Operation - Programming the disc tracks”).
TUNER – tune to the desired radio station.
USB – connect a USB mass storage device.
3 Press à or á repeatedly to set
the hour for the timer to start.
pg001-034_FWM377_12_Eng 2007.2.4, 16:3830
To Next Page
Loading...
