Philips FX15 - Getting Started with Your Hi-Fi; Initial Setup, Connections, and Safety

8 EN
3 Get started
Caution
•
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Connect antennas
• For better radio reception, connect the
supplied FM antenna to the ANTENNA
(FM) socket on the back of the main unit.
Connect speakers
Note
•
For optimal sound, use the supplied speakers only.
• Connect only speakers with impedance that is the
same or higher than the supplied speakers. Refer to the
Specications section of this manual.
FM
Note
•
Make sure that the colors of the speaker wires and
terminals are matched.
Insert the wire completely.
• Insert the right speaker wires to "R",
and left speaker wires to "L".
Connect power
Caution
•
Make sure that the power supply socket used can
support at least 10A current loading.
• Before connecting the AC power cord, make sure that
you have completed all the other connections.
• Connect the AC power cable to the wall
socket.