4 When the temperature light goes out, wait a while before you start
ironing.
During ironing, the temperature light goes on from time to time. This
indicates that the iron is heating up to the set temperature.
Note: The iron may give off some smoke when you use it for the rst time. This
stops after a short while.
Steam ironing
1 Make sure that there is enough water in the water tank.
2 Settherecommendedironingtemperature(seechapter‘Preparing
foruse’,section‘Settingthetemperature’).
3 Set the appropriate steam setting. Make sure that the steam setting
you select is suitable for the ironing temperature selected:
1 - 2 for moderate steam (temperature settings 2 to 3)
3 - 4 for maximum steam (temperature settings 3 to MAX)
Note: The iron starts to produce steam as soon as it has reached the
set temperature.
1 Set the steam control to position 0 (= no steam).
2 Settherecommendedironingtemperature(seechapter‘Preparing
foruse’,section‘Settingthetemperature’).
Spray function
You can use the spray function at any temperature to moisten the article
to be ironed. This helps remove stubborn creases.
1 Make sure that there is enough water in the water tank.
2 Press the spray button several times to moisten the article to be
ironed.
A powerful steam boost helps remove stubborn creases.
The steam boost function can only be used at temperature settings
between 2 and MAX.
-
-
ENGLISH6
To Next Page
Loading...
Need help?
General