General description
A Spray nozzle
B Filling cap
C Shot-of-steam button 9
D Steam control
E Spray button T
F Automatic shut-off light (GC4325/GC4320 only)
G Temperature light
H Temperature dial
I Alert light and automatic shut-off light (GC4340/GC4330 only)
J Type plate
K Water tank
L Calc-Clean button
M Soleplate
N Filling cup
Important
Read these instructions for use carefully before using the appliance and
save them for future reference.
◗ Check if the voltage indicated on the type plate corresponds to
the local mains voltage before you connect the appliance.
◗ If the appliance is provided with an earthed plug, it must be
plugged into an earthed wall socket.
◗ Do not use the appliance if the plug, the cord or the appliance
itself shows visible damage, or if the appliance has been dropped
or is leaking.
◗ Check the cord regularly for possible damage.
◗ If the mains cord is damaged, it must be replaced by Philips, a
service centre authorised by Philips or similarly qualified persons
in order to avoid a hazard.
◗ Never leave the appliance unattended when it is connected to the
mains.
◗ Never immerse the iron and the stand, if provided, in water.
◗ Keep the appliance out of the reach of children.
◗ Young children should be supervised to ensure that they do not
play with the appliance.
◗ This appliance is not intended for use by young children or infirm
persons without supervision.
◗ The soleplate of the iron can become extremely hot and may
cause burns if touched.
◗ Do not allow the cord to come into contact with the soleplate
when it is hot.
◗ When you have finished ironing, when you clean the appliance,
when you fill or empty the water tank and also when you leave
the iron even for a short while: set the steam control to position
0, put the iron on its heel and remove the mains plug from the
wall socket.
ENGLISH6
To Next Page
Loading...
