5. Press Preset timer to confirm the preset time.
6. Press Start/Reheat to start the cooking process.
7. When the preset time has elapsed, the All-inone
Multi Cooker starts working automatically.
Note
The preset function is not available in the following modes: Sauté/Sear (both low and
high temperatures), Reheat and Warm.
Assembling and disassembling the pressure regulator
Warning
Do not disassemble the pressure regulator during cooking. Always unplug the All-in-one
Multi Cooker and wait until the pressure has been released sufficiently to do so.
To disassemble the pressure regulator:
1. Turn the lower screw anticlockwise until it becomes loose.
2. Pull it up and take out the pressure regulator.
• To assemble the pressure regulator:
3. Assemble the lower screw back to the regulator.
4. Make sure the regulator points at the sealed position ( ) and put it back to the steam valve.
5. Turn the screw clockwise until it is fastened.
5 Cleaning and Maintenance
Note
Unplug the All-in-one Multi Cooker before starting to clean it.
Wait until the All-in-one Multi Cooker has cooled down sufficiently before cleaning it.
Interior
Inside of the top lid and the main body:
Wipe with wrung out and damp cloth.
Make sure to remove all the food residues stuck to the All-in-one Multi Cooker.
Heating element:
Wipe with wrung out and damp cloth.
Remove food residues with wrung out and damp cloth.
Sealing ring:
Soak in warm water and clean with sponge.
Inner lid:
Remove the detachable inner lid. Soak it in warm water and clean with sponge.
Exterior
Surface of the top lid and outside of the main body:
Wipe with a cloth damped with soap water.
Only use soft and dry cloth to wipe the control panel.
Make sure to remove all the food residues around the pressure regulator valve and floating valve.
Pressure regulator valve and floating valve:
Disassemble the pressure regulator, soak it in warm water, and clean with sponge.
To Next Page
Loading...
