4 Check if the tube release button works properly. When you
press the blue tube release button, the two clamps in the
opening have to move.
Note: If the clamps fail to move when you press the blue
tube release button, rinse the tube-connection hole under a
running tap again.
5 Put the tap unit onto the connection top of the keg by
pushing it down rmly (‘click’).
When you assemble the tap unit properly, you hear two clicks
in quick succession.
Tip: If you can move the arm of the connection top freely up
and down, the tap unit is placed properly on the keg.
6 Make sure the release buttons on either side of the tap
unit stick out equally far on both sides. If this is not the
case, press the release buttons on both sides with your
thumbs until you hear one click or two clicks in quick
succession.
Placing the tube into the tap unit
1 Insert the exible tube into the tap body.
2 Slide the projections of the tube connector under the hinge
points.
ENGLISH12
To Next Page
Loading...
