Philips HD3720 - Placing the Tap Unit onto the Keg; Clean Tap Unit Before Assembly; Remove Keg Protection Cap and Tube; Rinse Tap Unit Components

5 Attach the tap handle.
6 Place the preferred medallion on top of the handle.
Preparing for use
Placing the tap unit onto the keg
Always clean the tap unit with water and, if necessary, with
some washing-up liquid before you place it on the keg and
insert the tube. Table 1:
1 Remove the protection cap and the tube from the keg.
2 If present, remove the tube connector and the tube from
the tap unit. Hold the tap unit under a running tap and
rinse the tubeconnection hole (1) and the connection
to the body of the appliance (2). If necessary, use some
washing-up liquid.
3 Then turn the tap unit upside down and rinse the keg
connection in the bottom of the tap unit.
It is essential that all rubber parts of the tap unit are moist
before you assemble the tap unit onto the keg.
1
2
ENGLISH 11