Philips HD3802 - Connecting the hose to the water selection unit; Using the water purifier; Filtered water (spray or stream)

4 Tighten the attachment nut rmly onto the water selection
unit (Fig. 18).
Make sure the rubber washer is rmly pushed against the tap to prevent
water leakage.
Connecting the hose to the water selection unit
1 Make sure the tap is closed.
2 Set the water selection lever to the unltered stream
position (Fig. 19).
3 Cut the hose to the required length (Fig. 20).
4 Remove the hose joint from the water selection unit (Fig. 21).
5 Push the hose through the hose joint (1). Push the hose onto the
connection point until it does not go any further (2) (Fig. 22).
6 Tighten the hose joint (Fig. 23).
7 Use the nylon fasteners to fasten the hose along the tap (Fig. 24).
Using the water purier
The water selection unit has 4 settings: ltered spray, ltered stream,
unltered spray and unltered stream.
The unltered spray and stream come out of the water selection unit.
The ltered water comes out of the swivel nozzle. The swivel nozzle
has two settings: ltered spray and ltered stream.
Do not let water hotter than 50°C run through the water purier, as
this may damage the water purier.
Filtered water (spray or stream)
Select this setting for drinking, washing vegetables or fruits and
for cooking.
1 Turn the swivel arm to the desired position.
2 Turn the water selection lever on the water selection unit until the
ltered water symbol is aligned with the indicator (Fig. 25).
-
-
ENGLISH 11