Philips HD3802 - How to replace the filter cartridge; Environment; Guarantee & service; Troubleshooting

How to replace the lter cartridge
1 Close the tap and set the water selection lever to the unltered
stream position (Fig. 19).
2 Turn the cover anticlockwise to remove it from the lter
housing (Fig. 27).
3 Remove the cover with the lter attached from the lter
housing (Fig. 28).
4 Turn the lter cartridge clockwise to remove it (Fig. 29).
5 Screw the new lter cartridge anticlockwise into the cover of the
lter housing (Fig. 30).
6 Insert the cover with the cartridge attached into the lter
housing (Fig. 31).
7 Turn the cover clockwise to tighten it (Fig. 32).
Make sure the cover is tightened rmly.
Environment
Do not throw away the water purier with the normal household
waste at the end of its life, but hand it in at an ofcial collection point
for recycling. By doing this, you help to preserve the
environment (Fig. 33).
Guarantee & service
If you need service or information or if you have a problem, please visit
the Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country (you nd its phone number in the
worldwide guarantee leaet). If there is no Consumer Care Centre in
your country, go to your local Philips dealer.
-
ENGLISH14