3 Press the button for hot water.
The display reads ‘HOT WATER’ and 125ml of hot water comes out
of the hot water spout.
Do not use the hot water function for more than 2 minutes at a time.
The appliance is preset to produce 125ml hot water. You can change this
quantity as follows:
1 Attach the hot water spout to the nozzle.
2 Place a cup under the spout.
3 Press the button for hot water until the message ‘PROGRAM TO
SET VOL - HOT WATER’ appears on the display and then release it.
Hot water comes out of the hot water spout.
4 When the water in the cup reaches the required level, press
the button for hot water again to set the new quantity.
’SETTING DONE’ appears on the display. The appliance now
produces the set quantity until you change it again.
The coffee grinder is preset to the correct coarseness and should not
require frequent adjustment. You can select a coarser setting for less foam,
a normal aroma and faster brewing. You can select a ner setting for more
foam, a more intense aroma and slower brewing.
Only turn the grinding coarseness knob when the coffee mill is grinding.
,
,
,
EnglisH 17
To Next Page
Loading...
