Philips HD5730 - Preparing the Espresso Maker for Use; Filling and Inserting Water Tank; Inserting Hot Water Spout and Filling Beans

4 Rinsethewatertankandllitwithfreshwater.
Remove the lid to create a bigger lling opening.
5 Putthewatertankbackandpushitrmlyintoplace.
The message ‘INSERT WATER SPOUT’ appears.
6 Insert the hot water spout into the appliance.
7 Place a cup under the hot water spout.
8 Press the OK button.
Atrstinstallation,theappliancellswithwaterandhumsloudlyin
the process.
Theapplianceushesandthenswitchesoffautomatically.
9 Fill the coffee bean container with coffee beans.
Topreventmalfunction,neverllthecoffeebeancontainerwithground
coffee, freeze-dried coffee, caramelised coffee or anything else that could
damage the appliance.

1 Switch on the appliance again and press the MENU button.
2 Go to ‘SET CURRENT TIME?’ and press OK.
3 Set the hours and minutes of the current time (see section ‘Setting
current time’ in chapter ‘Setting menu parameters’).
4 Press the MENU button again, go to ‘SET WATER HARDNESS?’ and
press OK.
5 Set the local water hardness with the ^ or % and press the OK
button.
,
,
,
EnglisH 9