, The on/off button ashes slowly and the warning light goes out.
5 After a few seconds hot water stops coming out of the coffee spout.
, The machine is heating up.
Automatic rinsing cycle
When the machine has heated up, it performs an automatic rinsing cycle to
clean the internal circuit with fresh water. This takes approximately
one minute.
1 Place a bowl under the coffee spout.
, The on/off button ashes slowly.
2 Water ows from the coffee spout. Wait until the water stops
coming out of the coffee spout.
Note: You can stop the automatic rinsing cycle by pressing the coffee button.
3 When the on/off button lights up continuously, the machine is ready
to brew coffee.
Note: The automatic rinsing cycle also takes place 15 minutes after the
appliance switches to standby mode or switches off.
Note: The rst cups of coffee may be a bit watery, this is normal. The machine
needs to complete a few brewing cycles to optimise its settings.
ENGLISH 11
To Next Page
Loading...
