Problem Solution
The brewing unit cannot
be removed.
Remove the coffee grounds container before you open the maintenance
door. If you still cannot remove the brewing unit follow the next steps.
Reinsert the coffee grounds container, close the maintenance door, switch
on the machine. The machine prepares for use. Switch off the machine and
try to remove the brewing unit again.
The brewing unit cannot
be placed back.
Make sure that the lever is in contact with the base of the brewing unit.
Also make sure that the hook of the brewing unit is in the correct position.
See chapter ‘Cleaning and maintenance’, section ‘Cleaning the brewing unit’.
If you still cannot place the brewing unit back.Reinsert the coffee grounds
container and leave the brewing unit out. Close the maintenance door,
switch on the machine. The machine prepares for use. Switch off the
machine and try to place back the brewing unit again.
The machine grinds the
coffee beans but no coffee
comes out (see note).
Clean the coffee exit duct and set the grinder to a coarser setting. Clean
the brewing unit (see chapter ‘Cleaning and maintenance’, section ‘Cleaning
the brewing unit’).
Fill the water tank with water.
Clean the coffee spout.
The coffee is too
weak(see note).
Adjust the ceramic coffee grinder to a ner setting (see chapter ‘Using the
machine’, section ‘Adjusting the grinding degree’).
Brew a few cups of coffee to let the machine adjust itself to the new
grinding settings.
Use a different type of coffee beans.
Water ends up in the drip
tr ay.
This is normal. To guarantee the perfect cup of coffee, the machine uses
water to rinse the internal circuit and brewing unit. Some of the water
ows through the internal system directly into the drip tray. Empty the drip
tray regularly.
The machine seems to be
leaking.
The drip tray is full and overowed during brewing or the descaling
procedure.
Check if the water tank is leaking.
The brewing unit or the drains behind or under the brewing unit may be
blocked. Rinse the brewing unit with lukewarm water and clean the upper
lter carefully. Also clean the inside of the machine with a soft, damp cloth.
Coffee is brewed slowly
(see note).
The coffee grind is to ne. Change coffee blend or adjust the grind setting
(see chapter ‘Using the machine’, section ‘Adjusting the grinding degree’).
The brewing unit is dirty. Clean the brewing unit.
The water circuit of the machine has become blocked by scale. Descale
the machine.
Note: These problems can be considered normal if you have just installed the
machine or if the coffee blend has been changed.
ENGLISH 25
To Next Page
Loading...
