16
ENGLISH
4
Put the "INTENZA +" water lter into the empty water tank. Press it
down until it cannot move any further.
5
Fill the water tank with fresh water and reinsert it into the machine.
6
Dispense all the water in the tank by using the hot water function (see
the “Dispensing Hot Water” section).
7
Remove the tank, ll it with fresh water up to the MAX level and place
it back into the machine.
2
Remove the “INTENZA+” water lter from its packaging, immerse it ver-
tically (with the opening positioned upwards) in cold water and gently
press the sides so as to let the air bubbles out.
3
Set the “INTENZA+” water lter according to the hardness of the water
used:
A = Soft water
B = Hard water (standard)
C = Very hard water
Steady on
8
When the operations described above have been completed, the “ ”
light shines steadily. Machine is ready to brew co ee.
Note:
We recommend replacing the "Intenza +" lter every 2 months.
To Next Page
Loading...
