30
ENGLISH
6
Let the brew group air-dry thoroughly.
7
Thoroughly clean the inside of the machine using a soft, dampened
cloth.
8
Make sure the brew group is in the o position; the two reference signs
must match. If they do no match, proceed as described in step (9).
9
Gently pull down the lever on the back of the group until it is in con-
tact with the brew group base and the two reference signs on the side
of the brew group match.
10
Press the “PUSH” button rmly.
12
Insert the brew group in its seat again until it locks into place WITHOUT
pressing the “PUSH” button.
13
Insert the co ee grounds drawer. Close the service door.
11
Make sure that the hook which locks the brew group is in the correct
position. If it is still in the downward position push it upward until it
locks correctly into place.
To Next Page
Loading...
