7-1
7
PHILIPS MEDICAL SYSTEMS
7 DATA MANAGEMENT AND REVIEW
OVERVIEW
The HeartStart FR2+ is designed to make it easy to manage incident data. Some
information is automatically stored in the internal memory of the HeartStart
FR2+. More detailed data can be stored on a data card if desired. The incident
information stored in the HeartStart FR2+’s internal memory, or a summary of
the information recorded on the data card, can then be displayed on the
HeartStart FR2+ screen for review. In addition, HeartStart Event Review
software can be used on a personal computer to store and review the detailed
recorded information from a data card.
RECORDING INCIDENT DATA
The HeartStart FR2+ has two ways of recording information about an
emergency incident so that it can be reviewed after the incident: in internal
memory and on an optional data card.
RECORDING DATA IN INTERNAL MEMORY
Summary data for an incident is automatically recorded in internal memory by
the FR2+ while you are using it.
RECORDING DATA ON A DATA CARD
The M3854A data card can be used to store several hours of detailed incident
data, including events, ECG, and, optionally, audio.
IMPORTANT NOTE:To record incident data on a data card, the data card
must be installed before you turn on the FR2+.
CAUTION:The FR2+ is designed to be used only with Philips-approved
accessories. The FR2+ may perform improperly if non-approved accessories
are used.
Directions for installing a data card are provided in Chapter 2. To remove or
replace a data card after use, be sure to turn off the FR2+ in order to ensure
that no incident data are lost. Pull the data card tray out of the port in the FR2+
To Next Page
Loading...