EasyManua.ls Logo

Philips HL1659/28 - Juicer Mixer Grinder Operation; Operating the Juicer Mixer Grinder (HL 1654)

Philips HL1659/28
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
 
3
10. After operation, the appliance will stop on
its own
11 Turn speed selector knob to ‘Off position
(Fig. 27)
12. Press the button above the arm, to pull it in
upward direction (Fig. 28)
13. Press the button to unlock the jar (Fig. 29)
6.3 Juicer Mixer Grinder (HL 1654)
1. Connect the mains plug to the mains
socket (Fig. 30)
2. Switch on the mains supply
3. A neon lamp will light up to indicate the
power supply is on (Fig. 31)
4. Fix the juice collector into the appliance
and then turn it clockwise until you hear a
click sound (Fig. 32)
5. Place the pulp container into the appliance
by tilting it forward slightly. Insert the top
end fi rst and then push the bottom end
While you are preparing the juice, you can
empty the pulp container by switching the
appliance off and carefully removing the
pulp container
Note: Reassemble the empty pulp container
before you continue juicing
6. Put the fi lter in the juice collector. Make
sure the fi lter is fi tted securely onto the
driving shaft
Always check the sieve before use. If you
detect any cracks or damage do not use the
appliance and contact the nearest Philips
service centre or take the appliance to your
dealer (Fig. 33)
7. Hold the lid over sieve and lower it into
position
8. Fix the arm on the lid till you hear a click
(Fig. 34)
9. Turn speed knob to position 1 or 2 (Fig. 35)
Note : While juicing, appliance will not work in
speed knob position 3
10. Place the container under the spout
(Fig.36)
11. Put thr fruit in the feeding tube and gently
slide the pusher into the feeding tube by
aligning the groove in the pusher with the
small protrusion on the inside of the
feeding tube (fi g. 37)
Do not exert too much pressure on the
pusher, as this could affect the quality of the
end result and could even cause the fi lter
to come to a halt. Never insert your fi ngers
or an object into the feeding tube
12. Turn speed selector knob to ‘Off ’ position
and wait until the fi lter has stopped
rotating. Remove the pusher (Fig. 38)
13. Press the button above the arm, to pull it in
upward direction

Related product manuals