Philips HTL9100 User Manual

14 EN
5 Wall mount
your SoundBar
Before you mount your SoundBar on the wall,
read all safety precautions. (see 'Safety' on page
2)
Wall mount
Note
• You must detach the surround speakers from the main
unit before wall mounting or un-mounting.
• Improper wall mounting may result in accident, injury or
damage. If you have any query, contact Consumer Care
in your country.
• Secure the wall mount to a wall that can support the
combined weight of the product and the wall mount.
• Before wall mount, you need not remove the four
rubber feet at the bottom of the soundbar, otherwise
therubberfeetcannotbexedback.
Screw length/diameter
Depend on the type of wall mounting this wall
mount bracket, make sure that you use screws
of a suitable length and diameter.
For information about how to wall your
SoundBar, see the wall mount guide.
> 25mm
3 - 3.5mm
6 Product
specifications
Note
• Specicationsanddesignaresubjecttochangewithout
notice.
Amplier
• Total output power:
210W RMS (+/- 0.5 dB, 30% THD) /
168W RMS (+/- 0.5 dB, 10% THD)
• Frequency response: 20 Hz-20 kHz / ±3 dB
• Signal-to-noise ratio: > 65 dB (CCIR) /
(A-weighted)
• Input sensitivity:
• AUX: 400 mV
• AUDIO-IN: 220 mV
Audio
• S/PDIF Digital audio input:
• Coaxial: IEC 60958-3
• Optical: TOSLINK
Bluetooth
• Bluetoothproles:A2DP
• Bluetooth version: 2.1 + EDR
Main unit
• Power supply: 110-240 V~, 50/60 Hz
• Power consumption: 50 W
• Standbypowerconsumption:≤0.5W
• Speaker impedance:
• Woofer: 8 ohm
• tweeter: 8 ohm
• Speaker drivers: 2 x 63.5 mm (2.5") woofer
+ 2 x 25.4 mm (1") tweeter
• Dimensions (WxHxD):
1035 x 73 x 156 mm (with 2 surround
speakers attached)
• Weight: 3.9 kg

Philips HTL9100 Specifications

General

Brand	Philips
Model	HTL9100
Category	Speaker System
Language	English