Philips HU4811 - Getting Started; Prepare for Humidification; Using the Humidifier; Switching On and Off

5
EN
English
3 Gettingstarted
Prepareforhumidication
1 Hold by both sides of the upper unit and
lift it up (g b).
2 Remove the packaging material of the new
humidication lter (g c).
3 Assemble the new humidication lter
around the lter support (g d).
4 Put the lter and the lter support back
into the water tank (g e).
5 Fill the water tank with cold tap water until
water reaches the maximum water level
indication (g f).
6 Place the upper unit back onto the water
tank (g g).
4 Usingthe
humidifier
Switchthehumidieronand
off
1 Put the plug in the wall socket.
2 Turn the control knob to low speed or
high speed (g h).
» The speed light and the humidier are
on (g i).
3 Turn the control knob to OFF.
» The speed light is off.
» The humidier is off.
Note
• The humidier releases very ne invisible mist,
so it is normal that you cannot see the mist.
Waterlevel
When there is not enough water in the
water tank, the speed light will be off and the
humidier stops working. The control knob stays
at the chosen speed.
When you rell water, the humidier will
resume work at the chosen speed.
Note
• It is normal to nd some water left in the tank.