Philips HU4811 - Humidifier Maintenance; Refilling the Water Tank; Cleaning the Humidifier Body; Cleaning the Water Tank

6
EN
Rellwater
Water level can be observed through the
transparent water tank window.
1 Switch off the humidier and unplug it
(g j).
2 Hold by both sides of the upper unit and
lift it up (g b).
3 You can observe the water level through
the transparent water tank window. Fill
the water tank with cold tap water until
the water reaches the maximum water
indication level (g f).
Note
• When lling water, do not exceed the maximum
water level, or water might leak from the drain
hole and air inlets.
• Do not shake the water tank when moving it,
or water might leak from the drain hole and air
inlets.
• Do not ll water through the air outlets on top
of the humidier.
4 Place the upper unit back onto the water tank
(g g).
5 Cleaningyour
humidifier
Note
• Always unplug the humidier before you clean it.
• When pouring water from the water tank, make
sure to pour water from the opposite side of
the drain hole and air inlets.
• Never use abrasive, aggressive, or ammable
cleaning agents such as bleach or alcohol to clean
any part of the humidier.
• It is normal to have dust inside upper unit of the
appliance after using it for a while. User cannot
clean it by himself. Please contact local service
center for support.
Cleanthebodyofthe
humidier
Regularly clean the inside and outside of the
humidier to prevent dust from collecting.
1 Wipe away dust with a soft dry cloth from
the body of the humidier.
2 Clean the air inlet and the air outlet with a
soft dry cloth.
Cleanthewatertank
Clean the water tank every week to keep it hygienic.
1 Take out the humidication lter and the
lter support.
2 Fill the water tank for 1/3 with water.
3 Add some mild washing-up liquid to the
water in the water tank.
4 Clean the inside of the water tank with a
soft clean cloth.
5 Empty the water tank into a sink.
6 Put the humidication lter and the lter
support back into the water tank.